Cordless Glide n' Go Blackout Vinyl Roller Shade
Check Components
Prepare necessary tools
Warning
Avoid operating the shade up & down when the shade is not installed on a wall or in a window frame to prevent fabric sides from fraying.
STEP 1: DETERMINE INSIDE/CEILING, FLUSH, WALL OR OUTSIDE MOUNT
a. Inside/Ceiling or Flush Mount
(A minimum 2 1/4 in. depth is required or 3 1/4 in. depth for flush mounts.)
-
Position bracket approximately 1 to 2 inches from the ends of the headrail.
-
Mark the pre-drilled holes for the bracket using a pencil.
If you have more than 2 brackets, position it equally. -
Use the screws and anchors to install bracket holes.
b. Wall or Outside Mount
(A minimum 1 3/8 inch flat wall space is necessary)
-
Position brackets approximately 1 to 2 inches from the ends of the headrail. If you have more than 2 brackets, position it equally.
-
Mark the pre-drilled holes for the bracket using a pencil.
-
Use the screws and anchors to install the bracket holes.
STEP 2: MOUNT THE SHADE IN BRACKET
-
Insert the top of shade into the back hook of bracket.
-
Push the button on the front of the bracket and rotate the headrail upward until it is completely inserted, then release the button. Verify that the shade is securely attached before operating.
-
To remove the shade: while supporting the shade’s weight, push the button to release the shade. Rotate the headrail downward to remove from bracket hook.
STEP 3: HOW TO OPERATE
To lower the shade: Grip the handle and slowly pull it straight down.
To raise the shade: Grip the handle and lift it slowly to your desired position.
Important Note:
Always use the center of the handle when raising or lowering. This ensures the bottom edge stays parallel to the top and level. If the shade becomes unlevel, pull it fully to the bottom, then lift it back to the preferred height.
